How to Change iPhone Location | Spoof GPS Location on iPhone with Tenoshare iAnyGo (iOS 16 Supported)
Tecno ca6 dead after flashing with a bad firmware, solved
Forum rules
READ: GSM-Tutors Forum-Wide Rules and Regulations
READ: GSM-Tutors Forum-Wide Rules and Regulations
-
- Registered User
- Posts:2
- Joined:Sat Sep 08, 2018 11:02 am
- Location:Democratic Republic of the Congo
- Status:Offline
This is the successful story of how I saved my Tecno ca6 dead after flash with a bad firmware. to save a dead phone it feels good to have:
1. DA file corresponding to the model of your phone.
2. Aftersales downloader tool.
3. Factory signed firmware.
Procedure: Extract all the file mentioned above, open the file containing the DA file and copy your download agent, now go to aftersales download tool, in the folder MTKDA_FP and MTKDA_SP you delete the DA that you go find there and copy yours in this two folder after launch the SWD Aftersales application, once the tool is launched you will see a case on the right and click on tool and browse the folder located your firmware and select the scatter file, after choose the option *format all and download*. Then confirmed. After confirmation, always at the top right press start and wait for the tool to analyze the firmware. If analysis finishes now take your phone, press the volume up + down key and plug USB, if the DA connection ends, you can release the volume key but always leave usb plugged in until the download is complete.
Once the full download unplug usb and turn on the phone.
Done
1. DA file corresponding to the model of your phone.
2. Aftersales downloader tool.
3. Factory signed firmware.
Procedure: Extract all the file mentioned above, open the file containing the DA file and copy your download agent, now go to aftersales download tool, in the folder MTKDA_FP and MTKDA_SP you delete the DA that you go find there and copy yours in this two folder after launch the SWD Aftersales application, once the tool is launched you will see a case on the right and click on tool and browse the folder located your firmware and select the scatter file, after choose the option *format all and download*. Then confirmed. After confirmation, always at the top right press start and wait for the tool to analyze the firmware. If analysis finishes now take your phone, press the volume up + down key and plug USB, if the DA connection ends, you can release the volume key but always leave usb plugged in until the download is complete.
Once the full download unplug usb and turn on the phone.
Done
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1 Replies
- 3957 Views
-
Last post byRomShillzz
-
- 1 Replies
- 5043 Views
-
Last post byExclusive
-
- 1 Replies
- 5164 Views
-
Last post byExclusive
-
- 1 Replies
- 5114 Views
-
Last post byRomShillzz
-
- 1 Replies
- 3866 Views
-
Last post byRomShillzz