How to Change iPhone Location | Spoof GPS Location on iPhone with Tenoshare iAnyGo (iOS 16 Supported)
ITEL A12 FLASHED DONE WITHOUT DOWNLOADING ANY FIRMWARE
Forum rules
READ: GSM-Tutors Forum-Wide Rules and Regulations
READ: GSM-Tutors Forum-Wide Rules and Regulations
-
- Junior Member
- Posts:11
- Joined:Sun Jun 10, 2018 1:43 pm
- Location:Malawi
- Has thanked: 2 times
- Been thanked: 3 times
- Status:Offline
Requirements are miracle box v2.58, factory download tool and CM2..
First read flash from same itel that stuck on logo using cm2.Second convert that file into .pac There on cm2 aswell.Start flashing the phone using factory download tool,if operation stop while loading system file into the phone dont worry about that.If operation stoped then cancel factory tool then write flash using miracle boot 7731emmc...There on miracle untick all nv data files(3 files obsolutly) coz operation of flashing might not procceed..!! If done there in miracle the phone will just power on with black screen and contineuos vibration...
Then finally flash the .pac file u just converted using cm2..
NOTE..all above flashing process has to be done using .PAC file you just made.
When cm2 done then power on the phone...at this time it will boot succesfully with start up tone...then you are done.....all you needs is to repair imei...
Tested by GSM GTECH
Gsm Gtech
-
- Super Moderator
- Posts:28
- Joined:Mon Jun 11, 2018 7:42 am
- Location:Cameroon
- Has thanked: 5 times
- Been thanked: 10 times
- Status:Offline
Re: ITEL A12 FLASHED DONE WITHOUT DOWNLOADING ANY FIRMWARE
Anyone tried this yet?GSM GTECH wrote:
Requirements are miracle box v2.58, factory download tool and CM2..
First read flash from same itel that stuck on logo using cm2.Second convert that file into .pac There on cm2 aswell.Start flashing the phone using factory download tool,if operation stop while loading system file into the phone dont worry about that.If operation stoped then cancel factory tool then write flash using miracle boot 7731emmc...There on miracle untick all nv data files(3 files obsolutly) coz operation of flashing might not procceed..!! If done there in miracle the phone will just power on with black screen and contineuos vibration...
Then finally flash the .pac file u just converted using cm2..
NOTE..all above flashing process has to be done using .PAC file you just made.
When cm2 done then power on the phone...at this time it will boot succesfully with start up tone...then you are done.....all you needs is to repair imei...
Tested by GSM GTECH
Sent from my LGM-G600L using Tapatalk
Use Search Button to get Instant Results | Follow Forum Rules
Avoid Postings in wrong sections to prevent banning the offending account.
Avoid Postings in wrong sections to prevent banning the offending account.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 0 Replies
- 4178 Views
-
Last post byRomShillzz
-
- 2 Replies
- 2199 Views
-
Last post byvictor njawaya
-
- 1 Replies
- 6636 Views
-
Last post byEnglish
-
- 1 Replies
- 2948 Views
-
Last post byRomShillzz
-
- 1 Replies
- 3858 Views
-
Last post byRomShillzz