How to Change iPhone Location | Spoof GPS Location on iPhone with Tenoshare iAnyGo (iOS 16 Supported)
How To Fix Storage Type Mismatch (Scatter storage type EMMC | Target storage type NAND) In SP Flash Tool
Forum rules
READ: GSM-Tutors Forum-Wide Rules and Regulations
READ: GSM-Tutors Forum-Wide Rules and Regulations
-
- Administrator
- Posts:1301
- Joined:Fri Jun 15, 2018 12:00 pm
- Location:Nigeria
- Donate:
- Has thanked: 6 times
- Been thanked: 104 times
- Status:Offline
- Contact:
This is a tutorial on how to fix storage type mismatch (scatter storage type EMMC | target storage type NAND) when flashing firmware using SP Flash Tool.
Have you gotten an error while flashing a firmware using SP Flash Tool as shown on the image above or code below?
If Yes, then in this tutorial I'll be showing you how to fix this error.
WARNING!
Flashing will erase all of your data
All described operations you are doing at your own risk.
Requirements:
After getting the above requirement, Install Notepad++ and follow the steps below.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
You Might Also Like:
How To Fix Storage Type Mismatch (Scatter storage type EMMC | Target storage type NONE) In SP Flash Tool: viewtopic.php?f=104&t=277
If this worked for you, use the thanks button!
Have you gotten an error while flashing a firmware using SP Flash Tool as shown on the image above or code below?
Code: Select all
Storage type mismatch!
scatter storage type is HW_STORAGE_EMMC
target storage type is HW_STORAGE_NAND
WARNING!
Flashing will erase all of your data
All described operations you are doing at your own risk.
Requirements:
- SP Flash Tool:
- Notepad++: http://optitopt.com/396y
After getting the above requirement, Install Notepad++ and follow the steps below.
Step 1:
- Right-click on the firmware scatter file and open with Notepad++.
Step 2:
- Press CTRL+ F and search for the value "EMMC" (without the quotes).
Step 3:
- Rename all the EMMC to NAND.
Step 4:
- After renaming,
- Click on File and save the scatter file (you can also save the file using CTRL + S).
Step 5:
- Launch SP Flash Tool and select the scatter file again. Now the EMMC Scatter storage type has been successfully changed to NAND! You can now flash your device.
You Might Also Like:
How To Fix Storage Type Mismatch (Scatter storage type EMMC | Target storage type NONE) In SP Flash Tool: viewtopic.php?f=104&t=277
If this worked for you, use the thanks button!
Use Search Button to get Instant Results | Follow Forum Rules
Avoid Spams in the forum to prevent banning the offending account. | https://romshillzz.net
Avoid Spams in the forum to prevent banning the offending account. | https://romshillzz.net
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1 Replies
- 4065 Views
-
Last post byRomShillzz
-
- 0 Replies
- 5018 Views
-
Last post bydkdulal
-
- 0 Replies
- 8565 Views
-
Last post byRomShillzz
-
- 0 Replies
- 12017 Views
-
Last post byRomShillzz
-
- 0 Replies
- 3690 Views
-
Last post byRomShillzz