How to make a PC detect a Dead or Hard Bricked SPD (Spreadtrum) Device using RSTP Method
Posted: Thu Dec 06, 2018 2:10 pm
This is a tutorial on How to make a PC detect a Dead or Hard Bricked SPD (Spreadtrum) Device using RSTP Method. If you flashed an SPD device and it's no longer been detected by your Computer? Here's a fix!
Please Note: SPD Devices don't easily or totally die that way - ( Personification
).
Make sure you have properly installed Spreadtrum (SPD) Drivers in your Computer.
How To (Steps):
➜ Launch any Tool, Box or Dongle that supports the SPD device (or the tool you want to use)
➜ Load the firmware
➜ Click on the start button
➜ Hold Vol up + Vol down (the boot key)
➜ Plug / Connect the USB cable, then insert the battery to the device.
Now, the device should connect and be detected by your PC.
WARNING!
Flashing will erase all of your data
All described operations you are doing at your own risk.
This method is called RomShillzz Spreadtrum Test Point (RSTP).
If this worked for you, use the thanks button!
Please Note: SPD Devices don't easily or totally die that way - ( Personification
).Make sure you have properly installed Spreadtrum (SPD) Drivers in your Computer.
How To (Steps):
➜ Launch any Tool, Box or Dongle that supports the SPD device (or the tool you want to use)
➜ Load the firmware
➜ Click on the start button
➜ Hold Vol up + Vol down (the boot key)
➜ Plug / Connect the USB cable, then insert the battery to the device.
Now, the device should connect and be detected by your PC.
WARNING!
Flashing will erase all of your data
All described operations you are doing at your own risk.
This method is called RomShillzz Spreadtrum Test Point (RSTP).
If this worked for you, use the thanks button!